Home > Blog > Tips and Tricks > Balancing Your Low Wing Warbird With Retractable Gear

Balancing Your Low Wing Warbird With Retractable Gear

By Compo RC November 13th, 2026 19 views
There are two common approaches to setting the correct Center of Gravity for low-wing warbirds equipped with retractable landing gear.

Should you balance the model with the gear up or gear down? And is it better to balance it right-side up or inverted?

Let’s start with the landing gear position.
If you look into this topic online, you will see solid arguments for both methods.
Balancing with the gear up means you set the CG in your aircraft’s normal flying configuration.
Balancing with the gear down sets the CG for the most critical flight phases: takeoff and landing.

There is no universal perfect answer. Like many parts of this hobby, the choice largely depends on your personal preference. Even so, there are key factors you should consider before deciding what works best for your warbird.

If you balance while the gear is retracted, keep in mind that extending the gear may shift the CG forward or backward, depending on where the gear is mounted. You will need to compensate for this shift using radio trim, flight mode mixes, or stick input — and manual stick correction is not ideal during flight.

If you choose to balance with the gear deployed, the CG will be well suited for takeoff and landing. Once you retract the gear in flight, however, the CG may shift again, leaving you with very little room for error. You will also need to compensate for this change.

Whichever method you pick, always run ground tests to observe how the model behaves when the gear extends or retracts. If your transmitter supports it, set up a dedicated mix to counteract the CG shift automatically.

For example: suppose you balance your warbird with gear down. When you retract the gear, the model becomes tail-heavy. You can program a small amount of down elevator in your mix to gently lower the nose and offset this condition.

Next, should you balance low-wing warbirds inverted or right-side up?
Again, many hobbyists hold different opinions, and there is no single correct way. It all comes down to what works for you.

That said, most pilots prefer balancing low-wing models upside down. The main reason is practicality.
For a low-wing plane, the CG sits inside the fuselage, above the wing. Trying to balance the aircraft right-side up on your balance stand or fingertips is like balancing a small object on a sharp edge. When inverted, the CG hangs below the wing, making the whole process much simpler and more stable.

You can still get an accurate CG reading with the model right-side up, but the inverted method is generally easier to carry out.

We hope this guide helps you set up your warbird properly and enjoy many smooth, successful flights.
Happy Landings!
Previous
How Do Single-Hole Canopy Latches Hold an RC Airplane Canopy?
Read More
Next
Five Canopy Latches for Flight Box Spares and Trial Fitting
Read More